Feb 21, 2023 · 本文详细介绍了HFSS中的自适应网格剖分频率类型，包括单频点、多频点和宽带求解。 单频点在指定频率进行网格剖分，多频点和宽带则是对多个频率进行处理。 扫频设置中 …

May 18, 2016 · A sweep is a series of consecutive data point measurements taken over a specified sequence of stimulus values. You can make the following sweep settings: Press …

This commands sets the sweep type to LINEAR or LOGARITHMIC. The calculation for the measurement frequency points is based on this selection. Currently only one channel is …

Oct 9, 2004 · Below is a summary that will help you choose between different HFSS sweeps. Remeber that no matter which sweep you choose you should get the same results. The fast …

Sweep Modes and Input/Output Types. Measurement instruments use both internal (system) sweep and user sweep modes. This section describes each of these modes and the …

As seen in Fig. 1, HFSS has three types of sweeps; discrete, fast, and interpolating. Depending on your frequency bandwidth and processing power (i.e. how long you are willing to wait for …

Feb 1, 2017 · The discrete sweep is the most accurate as it resolves the problem at each frequency point in your whole frequency range. However, it is the slowest and the adaptive …

:SENSe:SWEep:TYPE Description. This commands sets the sweep type to LINEAR or LOGARITHMIC. The calculation for the measurement frequency points is based on this selection.

SWEep - Each Manual or External trigger signal causes ALL traces that share a source port to be swept. POINt - - Each Manual or External trigger signal causes one data point to be measured.

To set the sweep type, use the following softkeys: Stimulus > Sweep Type. Then select the sweep type: • Lin Freq — Linear frequency sweep. • Log Freq — Logarithmic frequency sweep. • …