Complete E47 and E57 pumps are no longer available. All these units are now replaced with a genuine E58H Electro Lift Power Unit from Meyer. Mill Supply does carry all the replacement parts for the E47, E47H, E57 and E57H pump assemblies.

These instructions are intended as a guideline for overhaul of an E-46/E-47 Electro-Lift® unit. More detailed information covering principles of Operation, Troubleshooting, Disassembly and Repair are found in Electro-Lift® Service Manual 1-562. This is available for a nominal fee from your Meyer Distributor or directly from Meyer Products.

Motor to Pump Mounting Screws - Torque to 45 - 55 inch pounds. Seal screw heads with non-hardening gasket sealer such as Form-a-Gasket #2 per Meyer Service Bulletin No.72 below. If you disassemble your motor for cleaning and inspection, remember that it is important to assemble it properly.

DME Mfg 15697, Meyer B Valve Assembly, Valve, 15698, Coil, 15382, for E47, E57, E60 Pumps, Aftermkt, Optional 18-8 Stainless Steel Nut Inclu...

Dec 26, 2010 · I'm no expert but the first thing I would do is check the connections at the motor and check the grounds. Then I would use a set of jumper cables and put power directly to the motor from the battery to see if the motor is any good.

Feb 11, 2025 · Rebuilt Meyer E47 E-47 Snow Plow Pump ( New Ram & Motor & Coils!) A properly rebuilt automotive part. The item has been completely disassembled, cleaned, and examined for wear and breakage. Worn out, missing or non-functioning components have been replaced with new or rebuilt components.

Jan 4, 2010 · Hi, my dad's meyers e47 started acting like the motor was going bad this morning. it was working fine till half way through a job and it wouldn't lift or angle. we replaced the motor with a new meyers motor and nothing. it would just make a clicking sound and the lights on the control pad would go out when pressed and cause the motor to die if ...